Today, I'd like to briefly introduce the installation method of windproof rolling shutter door, hoping to help you.

　　1.卷帘门在装置大轴之前，先将牢固偏向的挂板装置在卷轴上，然后将4-6片帘板装置在挂板上，并卷在卷轴上的四川丝上。

　　1. Before installing the main shaft of the rolling shutter, first install the hanging plate with fixed direction on the rolling shaft, then install 4-6 pieces of the curtain plate on the hanging plate, and roll them on the Sichuan silk on the rolling shaft.

　　2.提升快门门轴,必须注意,设置一个特殊的命令,hermitage梯子,脚手架,手起重机必须经过检查,百叶窗装置将笼罩轴承和阀座的光学轴端孔的盘,对齐后轴承牢固螺栓紧固。

　　2. Pay attention to the safety when lifting the shutter door shaft. Set a special command. Hermitage ladder, scaffold and crane must be inspected. The shutter installation will cover the plate of the optical shaft end hole of the bearing and the valve seat. After alignment, the bearing fixing bolts shall be fastened.

　　3.卷筒装好后，可以左右移动卷筒调解其位置，同时用水平尺和水平管检查卷筒的水平。

　　3. After the drum is installed, it can move the drum left and right to adjust its position, and check the level of the drum with a level ruler and a horizontal pipe.

　　4.吊装卷筒时要特别注意不要损坏卷在轴上的帘板，用钢丝绳捆扎时要垫好帘板。

　　4. Pay special attention not to damage the curtain plate rolled on the shaft when hoisting the drum, and pad the curtain plate when binding with steel wire rope.

　　看了济南卷帘门厂家上面的介绍，相信各人对它有了一定的了解。如果您有任何疑问，接待来电咨询，我们竭诚为您效劳。

　　After reading the introduction of Jinan roller shutter door manufacturer, I believe you have a certain understanding of it. If you have any questions, welcome to inquire, we will serve you wholeheartedly.