联系Z6尊龙官方网站官网入口
Z6尊龙官方网站官网入口
联系人：林经理
电话：151 6888 2846
邮箱：527800164@qq.com
地点：济南市历下区化纤厂路8号3号楼101号
车库门电机保养要注意哪些内容 ？
1、车库门的日常使用情况应坚持干燥 ，不得处于湿润的情况中 ，电机的外貌应坚持清洁 ，特别是进风口不得受灰尘、纤维等杂质的阻碍。
1. The daily use environment of the garage door should be kept dry and not in a damp environment. The surface of the motor should be kept clean, especially the air inlet should not be obstructed by impurities such as dust and fibers.
2、包管车库门电机在运行历程中有良好的润滑。一般来说 ，车库门电机运行每5000小时左右 ，就要增补或更换润滑脂 ，若运行中发明轴承过热或润滑变质时 ，应实时液压或换润滑脂。更换润滑脂时 ，应先旧的润滑油 ，并用汽油洗净轴承及轴承盖的油槽 ，然后将润滑脂填充在轴承内外圈之间的空腔的1/2、2/3处。
2. Ensure that the garage door motor has good lubrication during operation. Generally speaking, the garage door motor needs to be replenished or replaced with lubricating grease every 5000 hours of operation. If bearings are found to be overheated or the lubrication deteriorates during operation, hydraulic pressure or lubricating grease should be replaced in a timely manner. When replacing lubricating grease, the old lubricating oil should be removed first, and the oil grooves of the bearing and bearing cover should be cleaned with gasoline. Then, the lubricating grease should be filled in the 1/2 and 2/3 spaces between the inner and outer rings of the bearing.
3、各人当车库门电机的热�；ち⒄穸� ，必须要先查明故障来自哪个偏向 ，看电机照旧超负荷或�；ぷ爸谜ㄖ堤偷奈侍� ，待故障后 ，才华投入正常运行中。
3. When the thermal protection of the garage door motor continuously vibrates, it is necessary to first identify the direction of the fault, whether the motor is overloaded or the protection device setting value is too low. After the fault is eliminated, it can be put into normal operation.
4、一旦发明车库门电机运行的振动及噪声明显增大时 ，就说明电机轴承的寿命已抵达极限 ，这时需要检查轴承的径向游隙是否抵达相关数值 ，并实时更换新的电机轴承。
4. Once it is found that the vibration and noise of the garage door motor have significantly increased, it indicates that the service life of the motor bearings has reached its limit. At this time, it is necessary to check whether the radial clearance of the bearings has reached the relevant values and replace them with new motor bearings in a timely manner.
5、若车库门电机爆发故障 ，必须要拆卸时 ，轴伸端或非伸端处都可以取出转子。若需要从定子中抽出转子时 ，应注意避免损坏定子的绕组或绝缘。
5. If the garage door motor malfunctions and must be disassembled, the rotor can be removed at both the shaft extension end and non extension end. If it is necessary to extract the rotor from the stator, attention should be paid to preventing damage to the stator winding or insulation.
下一篇：济南电动卷帘门的尺寸巨细及装置办法 上一篇： 电动卷帘门� ？仄魇Я榈脑蛴心男� ？
阅读/ Recommended reading
- 济南卷帘门的优点剖析 2024-12-16
- 济南卷帘门的装置指南：办法与注意事项 2024-12-11
- 济南卷帘门的维修保养：延长使用寿命的要害 2024-12-09
- 济南卷帘门：卷帘门� ？仄魇Я槭笔允员疚牡囊彀桑� 2024-11-16
- 电动卷帘门的优势 2024-11-12
- 济南卷帘门：卷帘门� ？仄魇Я樵趺窗� ？ 2024-09-02
- 济南卷帘门厂：卷帘门卡主了怎么办 2024-08-28
- 济南电动卷帘门：电动卷闸门没电了怎么开? 2024-08-28
车库卷帘门故障及维修要领
2024-12-23
车库卷帘门在使用历程中可能会遇到种种故障 ，以下是一些常见的故障及其维修要领： Garage rolling shutter doors may encounter vario...
