�？鼐砹泵诺淖爸靡旒疤氐鉥公司新闻_新闻资讯-Z6尊龙官方网站官网入口

公司新闻

首页>>新闻资讯>>公司新闻�？鼐砹泵诺淖爸靡旒疤氐�

公司新闻

新闻资讯

联系Z6尊龙官方网站官网入口

Z6尊龙官方网站官网入口

联系人：林经理

电话：151 6888 2846

邮箱：527800164@qq.com

地点：济南市历下区化纤厂路8号3号楼101号

�？鼐砹泵诺淖爸靡旒疤氐�

来源：日期：2022-07-28 宣布人：

�？鼐砹泵啪哂械南宰盘氐憔褪强焖�，这种快速就是体现在其卷帘门的技术含量上，那么，关于卷帘门的使用我们应该注意其特点，这样才华让卷帘门获得更好的使用。下面来讲讲吧。

The remarkable characteristic of remote control rolling shutter door is fast. This speed is first reflected in the technical content of the rolling shutter door. Then, we should pay attention to its characteristics for the use of rolling shutter door, so that the rolling shutter door can be better used. Now let's talk about it.

�？鼐砹泵抛爸盟枰玫降墓ぞ吆屠�

Tools and processes required for the installation of remote control roller shutter door

�？鼐砹泵旁谖颐堑纳钪斜还惴菏视糜谝揭�，货仓，物流，冷冻品等地方使用，主要起到了防尘，防水，隔热隔冷，防虫，防沙灰尘等主要特性。那么，关于�？鼐砹泵抛爸盟枰玫降墓ぞ吆屠淌窃跹哪�？

Remote control rolling shutter door is widely used in medicine, warehouse, logistics, frozen goods and other places in our life. It mainly has the main characteristics of dust prevention, waterproof, heat insulation, cold insulation, insect prevention, sand and dust prevention. Then, what are the tools and processes required for the installation of remote control roller shutter doors?

1、须要工具

1. Necessary tools

角磨机、手枪钻、水平仪、攻击钻，拖线板，转头螺丝，螺丝刀、锤子，扳手，脚手架等等。

Angle grinder, pistol drill, level gauge, impact drill, drag line board, swivel screw, screwdriver, hammer, wrench, scaffold, etc.

2、主质料

2. Main material

门帘、导轨、轴承、编码器，红外比照，箱罩等主要部分组成。

Door curtain, guide rail, bearing, encoder, infrared contrast, box cover and other main parts.

3、辅助硬件

3. Auxiliary hardware

装置的须要条件，电源220v，洞口平整等。

Necessary conditions for installation, power supply 220V, hole leveling, etc.

4、出厂前的检查

4. Pre delivery inspection

对�？鼐砹泵沤胁鸢觳�，检察产品是否有漏件，核对产品出厂单，并开始着手装置。

Unpack and check the remote control roller shutter door to see if there are any missing parts, check the product delivery order, and start the installation.
济南卷帘门厂

作业条件

Operating conditions

1、结构工程施工完毕，粗装修之后、细装修之前，好墙面基础灰已完成，面层灰尚未施工前。

1. After the construction of structural works, after the rough decoration and before the fine decoration, the bottom ash of the wall has been completed, and the surface ash has not been constructed.

2、洞口尺寸及埋件位置、数量、规格切合设计要求。

2. The size of the opening and the position, quantity and specification of the embedded parts meet the design requirements.

3、进场产品验收及格。各部分相互匹配，配件齐全。

3. The mobilized products have passed the acceptance. Each part is matched with each other, and the accessories are complete.

装置导轨

Install the guide rail

将两则导轨按线焊牢于墙体预埋件上，施焊前注意吊笔直线检查导轨装置部位墙体笔直度，达不到笔直度要求时须加垫铁调笔直后方可施焊。

Weld the two guide rails on the embedded parts of the wall according to the line. Before welding, pay attention to hanging the straight line to check the verticality of the wall where the guide rail is installed. If the verticality requirement is not met, add a sizing block to adjust the verticality before welding.

调试

debugging

济南卷帘门厂认为要视察检查卷筒体、帘板、导轨和传动部分相互之间的吻合接触状况及运动间隙的匀称性，然后用手缓慢向下拉动关闭，再缓慢匀速向上拉提到位，重复频频，发明有阻滞顿卡或异常噪音时仔细检查爆发原因后进行调解，直提拉顺畅，用力匀称为。对电控卷帘门，手动调试后再用电动机启闭数次，细听有无异常声音。

Jinan rolling shutter factory believes that it is necessary to observe and check the contact condition between the drum body, curtain plate, guide rail and transmission part and the symmetry of the movable gap, then pull it down slowly and close it by hand, and then pull it up slowly and evenly to the right place. Repeat it for several times. If there is blocking, jamming or abnormal noise, carefully check the cause and adjust it until the lifting is smooth and the force is even. For the electrically controlled roller shutter door, after manual debugging, use the motor to open and close it several times, and listen carefully for abnormal sound.

卷帘门装置历程中注意�；ざ纯谥鼙咦笆尾�。装置后洞口周边修补抹灰或装饰罩面时飞溅到卷帘门上的灰浆须实时用湿棉砂擦净。更多相关注意事项您可以关注我们网站获取到。

During the installation of roller shutter door, pay attention to protect the decorative layer around the hole. After installation, when repairing the plastering or decorative cover around the hole, the mortar splashed on the roller shutter door must be wiped off in time with wet cotton sand. For more relevant precautions, you can follow our website Get.

下一篇：卷帘门厂家教你车库门�？仄魅绾味月� 上一篇：�？鼐砹泵诺闹饕爸煤褪褂靡�